Universal Security Instruments USI-1209 Troubleshooting Guide

Browse online or download Troubleshooting Guide for Unknown Universal Security Instruments USI-1209. Universal Security Instruments USI-1209 Troubleshooting Guide User Manual

  • Download
  • Add to my manuals
  • Print
  • Page
    / 1
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 0
C O N D I T I O N / S O L U T I O N
RED LED
GREEN LED
Flashes On once every
40-45 seconds
Stays On AC Power is present.
Flashes On once every
40-45 seconds
Off
AC Power is not present. Check the breaker or fuse box for power. If the breaker or
fuse box looks normal, call a licensed electrician for assistance.
3 Beeps, 2 second
pause, 3 Beeps
Flashes On once
per second
Stays On
The test button has been pressed. The test sequence lasts for approximately 3-10
seconds.
3 Beeps, 2 second
pause, 3 Beeps
Flashes On once
per second
Stays On Originating smoke alarm - the alarm has sensed smoke.
3 Beeps, 2 second
pause, 3 Beeps
Does not Flash On
once per second
Stays On Non-originating smoke alarm - an interconnected smoke alarm has sensed smoke.
Single Chirp every 40
seconds
Flashes On once every
40-45 seconds
Stays On
Low Battery. Turn off AC Power and replace the 9V battery (see user's manual for
recommended type of battery). Also check to make sure the polarity is correct for the
battery terminals.
Horn sounds when
no visible hazard
present
Flashes On once
per second
Stays On
Please take all precautions if an alarm sounds by calling an Emergency Service and
getting out of the home. If there is no visible hazard present, turn off AC Power at the
circuit breaker or fuse box and disconnect the alarm from the mounting bracket and
make sure the connector plug is securely attached. Press the test button to see if
the alarm is functioning properly. Check that the alarm is mounted in the correct
location away from areas with high humidity or turbulent air (refer to user's manual).
Horn does not sound
when other alarms are
active or horn does not
sound when
interconnected alarms
test button is pressed
Off Off
Press and hold the test button longer. Check the remote smoke alarms are receiving
power and are functioning properly. Turn off AC Power at the circuit breaker or fuse
box and disconnect the alarm from the mounting bracket and make sure the
connector plug is securely attached. Have the wiring checked by a licensed
electrician to make sure all the interconnect points are connected.
USI-1209 AC/DC SMOKE ALARM OPERATIONAL SUMMARY
*NOTE: If you have any additional questions about your USI-1209, please contact our Customer Service Department at 1-800-390-4321 and we will gladly assist you.
A L A R M A U D I B L E & V I S U A L S I G N A L S
HORN
© 2006 USI ELECTRIC, INC.
Page view 0
1

Summary of Contents

Page 1 - © 2006 USI ELECTRIC, INC

C O N D I T I O N / S O L U T I O NRED LEDGREEN LEDFlashes On once every 40-45 seconds Stays On AC Power is present.Flashes On once every 40-4

Comments to this Manuals

No comments